Exit status 74 uploading to Curie

Discussion in 'UDOO X86' started by ghiglie, Aug 21, 2017.

  1. ghiglie

    ghiglie New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    2
    Hi there,
    I'm facing this problem while uploading the FirmataBLE sketch to Curie, from CentOS with Arduino IDE 1.8.3 .
    I've followed all the links available, tried to push the master reset button but it didn't help too.
    Any ideas?

    Thanks,
    Marco
     
    ghiglie, Aug 21, 2017
    #1
  2. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,314
    Likes Received:
    580
    Do you have problems with every sketch you want to upload or just this one?
     
    waltervl, Aug 21, 2017
    #2
  3. ghiglie

    ghiglie New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    2
    Every one. Just installed arduino-core and ino script - getting a "programmer is not responding" with the "blink" test.

    My /dev/ttyACM0 should be ok, it has "crw-rw-rw- 1 root dialout" permissions.
     
    ghiglie, Aug 21, 2017
    #3
  4. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,314
    Likes Received:
    580
    What I did to solve this upload issue (next to setting some access rules as mentioned in the installation manual) was to reboot the udoo, press Arduino master reset button and then upload. It started with a ble firmware update for the Curie and then started to upload.
     
    waltervl, Aug 21, 2017
    #4
    LDighera and ghiglie like this.
  5. Laura

    Laura UDOOer

    Joined:
    Apr 22, 2016
    Messages:
    374
    Likes Received:
    156
    Laura, Aug 21, 2017
    #5
  6. ghiglie

    ghiglie New Member

    Joined:
    Jul 29, 2017
    Messages:
    3
    Likes Received:
    2
    ghiglie, Aug 25, 2017
    #6
    Laura and waltervl like this.

Share This Page