Recent Content by Brendan Hansknecht

  1. Brendan Hansknecht
    Post

    Analog input

    So I tested using 3.3 and 4096 as the numbers in the equation and the voltage measure now works besides it reads about .1 volts lower than the...
    Post by: Brendan Hansknecht, Nov 25, 2015 in forum: UDOO NEO
  2. Brendan Hansknecht
    Post

    Analog input

    Thanks for the reply. Based on that, if I set the udoo neo to use external reference and then plug in 5V into the aref pin it should give me...
    Post by: Brendan Hansknecht, Nov 25, 2015 in forum: UDOO NEO
  3. Brendan Hansknecht
    Post

    Analog input

    Just to give people an idea of my circuit and code, I have a 10k pull down resistor between A0 and gnd. And then I connect a battery to...
    Post by: Brendan Hansknecht, Nov 25, 2015 in forum: UDOO NEO
  4. Brendan Hansknecht
    Thread

    Analog input

    So I was trying to read analog voltage using the udoo neo and I am getting numbers that are out of wack. The expected range for an arduino is 0 -...
    Thread by: Brendan Hansknecht, Nov 25, 2015, 11 replies, in forum: UDOO NEO