Recent Content by dnulnets

  1. dnulnets
    Post

    Serial port CN6 not working as expected

    Thanks for the info, that explains it :-)
    Post by: dnulnets, Nov 4, 2014 in forum: Troubleshooting
  2. dnulnets
    Post

    TCP/IP <=> Serial Gateway

    Hi, I'm sorry but I am no python guy and cannot answer your question. But I had the need for something similar, i.e. to be able to communicate...
    Post by: dnulnets, Nov 4, 2014 in forum: General Programming Discussion
  3. dnulnets
    Post

    Serial port CN6 not working as expected

    Hi again, one side effect I have seen is that the IOMUXC_SW_MUX_CTL_PAD_KEY_COL0 seems to get reset to 4 whenever I reset the arduino through J16...
    Post by: dnulnets, Oct 7, 2014 in forum: Troubleshooting
  4. dnulnets
    Post

    Serial port CN6 not working as expected

    Hi, that did it, now it works perfectly :-) Thanks :D I also thought about shutting down or never starting ttymxc3 before posting but didn't...
    Post by: dnulnets, Oct 7, 2014 in forum: Troubleshooting
  5. dnulnets
    Post

    No i2c data to adafruit motor shield V2

    Hi, I have currently written a set of functions handling the adafruit motor shield v2 for DC-motors using the twi interface in ASF and compiled...
    Post by: dnulnets, Oct 7, 2014 in forum: General Programming Discussion
  6. dnulnets
    Post

    Eclipse IDE + Atmel ASF as alternative to Arduino IDE

    INPUT It was a while ago this thread was alive, but thanks for showing that it was doable - so I wouldn't give up :D But anyway I'm currently...
    Post by: dnulnets, Oct 7, 2014 in forum: General Programming Discussion
  7. dnulnets
    Thread

    Serial port CN6 not working as expected

    Hi, I'm having some problems with the serial interface to the Arduino from an external computer running Fedora 20. I have attached the external...
    Thread by: dnulnets, Oct 6, 2014, 8 replies, in forum: Troubleshooting