Cant seem to edit my own post, so forgive me for the double post... I spoke abit too soon on my troubles, after abit of googling i got a gui, and...
Im very excited by this, as i hope one of the things fixed in this version is my problem with installing arduino ide 1.8.5 or whaterver i needed...
tried using armbian, but it cant find the arduino due on the port i think ill just use udoobuntu 2.2 and leave the newest firmware for the time...
Im on a udoo Quad, i will try. I do have both 1.6.5 and 1.8.5 currently installed, there might be some fault cause of that. But im also having...
So i needed to upgrade my IDE for newest version of firmware on my 3d printer. And a lot of problems started. And i dont really know linux well...
I finally got the circuit today, and had it replaced. But im slighty worried that something else went wrong during the short circuit. I cant seem...
awesome, thanks for the answer :D Thank you, i bought 3 of the circuits just incase i manage to make a big booboo again :)
Hi, so while lvling my heatbed on my 3dprinter, i managed to short circuit over a LED, and thats it for my poor ATSAM3X8EA-AU circuit. After a...
Well i feel like a propper idiot now.... In all my haste i didnt realize that the 3 pin connector was 180 degrees wrong on those that made it...
Its running udoobuntu 2.0 Its connected into an arduino shield so im not sure on what pins, how do i figure that out? :P
Hi, So i finally have started building my 3d printer, using udoo quad and radds 1.5. There is ofcourse some bugtesting to be done. And one of the...
So it seems its the ATSAM3X processor that has died. RMA from mouser(where i ordered it from) :)
Separate names with a comma.
