Recent Content by Flavio Battimo

  1. Flavio Battimo
    Post

    Video capture using gstreamer

    Hello, any update on the VADC issue?
    Post by: Flavio Battimo, Feb 24, 2016 in forum: UDOO NEO
  2. Flavio Battimo
    Post

    flexcan on NEO?

    Hi Andrea, I have checked GPIOs and actually each line I have tested is not working. I tried with: GPIO_4 GPIO_116 GPIO_127 GPIO_124 GPIO_119...
    Post by: Flavio Battimo, Feb 18, 2016 in forum: General Discussion
  3. Flavio Battimo
    Post

    flexcan on NEO?

    Hello Davide, my goal is to get access canbus from M4 core in order to reduce load on A9. So I'm waiting for software implementation based on MQX.
    Post by: Flavio Battimo, Feb 10, 2016 in forum: General Discussion
  4. Flavio Battimo
    Post

    Video capture using gstreamer

    Hello, this is the cli command I have used. GST_DEBUG=2,*imx*:9 gst-launch-1.0 imxv4l2videosrc device=/dev/video0 num-buffers=2 ! jpegenc !...
    Post by: Flavio Battimo, Jan 28, 2016 in forum: UDOO NEO
  5. Flavio Battimo
    Post

    flexcan on NEO?

    Hi Andrea, any update on the MQX software implementation and canbus documentation? I would like to start playing with can bus on UDOO NEO but I...
    Post by: Flavio Battimo, Jan 12, 2016 in forum: General Discussion
  6. Flavio Battimo
    Thread

    Video capture using gstreamer

    Hello, I have uploaded the OS to the latest revision (UDOObuntu 2 RC1). What about video recording from the analog source? Does an update is...
    Thread by: Flavio Battimo, Jan 11, 2016, 13 replies, in forum: UDOO NEO
  7. Flavio Battimo
    Post

    flexcan on NEO?

    Hello Andrea, do you mean that disable state in dtb file means flexcan is accessible from M4?
    Post by: Flavio Battimo, Nov 14, 2015 in forum: General Discussion
  8. Flavio Battimo
    Post

    flexcan on NEO?

    Hello, have you managed to work with FlexCAN on Neo board?
    Post by: Flavio Battimo, Nov 11, 2015 in forum: General Discussion
  9. Flavio Battimo
    Post

    5 volt tolerance

    Hello John, this is the same trick I used on banana pi. My disappointment is that an Arduino Uno shield could have 5 volt signals. I thought that...
    Post by: Flavio Battimo, Nov 5, 2015 in forum: UDOO NEO
  10. Flavio Battimo
    Thread

    5 volt tolerance

    Hello, Does M4 core is 5 volt tolerant on gpio pins? I want to connect a HC-SR04 ultrasonic distance sensor. It is 3.3 volt tolerant on trigger...
    Thread by: Flavio Battimo, Nov 4, 2015, 6 replies, in forum: UDOO NEO
  11. Flavio Battimo
    Post

    Connector Types

    Hello, what about J12 connector for VADC on Udoo Neo. Where can I buy the female housing?
    Post by: Flavio Battimo, Nov 3, 2015 in forum: Accessories