I don't have my board with me this weekend. I'll try the image on Monday and post the results.
I'm cross compiling using an Ubuntu 14.04 image running in a VM. I had tried installing the too chain earlier and gotten the same error as...
OK, I want to use the Vin/Gnd without the barrel jack, which is working great! Thanks.
Using Vin/GND pins on the inner header I've powered the board using 6V, 7V, and 12V (5V did not power). I've powered the board using the micro...
Yes, no problems.
Yes, I've powered it up using 6V, 7V, and 12V. It would not power up at 5V. I've been using 12V for a couple of days with no problems.
Through the USB connection: >ssh udooer@192.168.7.2 $ minicom -D /dev/ttyMCC ctrl-A q to quit minicom
It doesn't boot at 5V but it does at 6V and above (I tested at 6V, 7V, and 12V). Thanks.
No power light. I'm using a programmable power supply set at 3.3V output with a max of 2A. It shows no current draw.
What is the max voltage for VIN? 3.3V? 5V?
The Udoo Neo doc pages in Power Management have: Power sources You can power up the board in 3 ways DC-jack: internal positive, Voltage 6 to...
I have the same problem: sudo dpkg --configure -a Setting up dtweb (1.13) ... Removing dtbkernel... 3 /var/lib/dpkg/info/dtweb.postinst: 13: [:...
The above thread did help me find the missing udooclient and fix the problem: In folder /Users/<user>/Library/Arduino15/staging/packages, I found...
I want to program the Neo M4 from my Mac (El Capitan) using the Arduino IDE v1.6.9 over the network. So, I followed these directions...
Separate names with a comma.
