Recent Content by Karthikeyan Jaganathan

  1. Karthikeyan Jaganathan
    Thread

    Not Powering up

    I have been using UDOO Quad for my project for months. Today, I had powered up the UDOO and edited my program. But after that when I power up...
    Thread by: Karthikeyan Jaganathan, Dec 24, 2015, 1 replies, in forum: UDOO QUAD
  2. Karthikeyan Jaganathan
    Post

    PWM on pins, i.MX6, UDOO Quad, UDOObuntu?

    To change the frequency of the PWM signals we have to have access to the pre scalar values of the Timers. My doubt is which timer corresponds to...
    Post by: Karthikeyan Jaganathan, May 27, 2015 in forum: General Programming Discussion
  3. Karthikeyan Jaganathan
    Post

    Pwm on SAM3x and control on iMx6

    Hi, If I use the command analog write to produce the PWM waves, the maximum duty cycle achievable was around 1200 microseconds......... but for...
    Post by: Karthikeyan Jaganathan, May 23, 2015 in forum: Arduino IDE