Recent Content by Max

Post

I did some tests and if you stop Udoo at boot stage it works but if Openelec is running it's impossible to program the SAM3X neither...

Post by: Max, Aug 20, 2015 in forum: Arduino IDE

Post

Ok, thanks for the explanation, now I understand, but this was not written in the tutorial so I thought it would work with any OS. In fact...

Post by: Max, Aug 16, 2015 in forum: Arduino IDE

Post

Ok, I didn't know that the "erase and reset" part was done by the i.MX6, sorry. I downloaded Openelec from your website so I think it's the right...

Post by: Max, Jul 29, 2015 in forum: Arduino IDE

Post

So it isn't possible to upload sketches if I want to use Openelec as OS? Isn't it a bit weird? I mean, if the J18 jumper is unplugged the CN6 port...

Post by: Max, Jul 27, 2015 in forum: Arduino IDE

Post

I also tried using a different operating system, Udoobuntu instead of Openelec, on the microSD (even if uploading the sketch on the SAM3X...

Post by: Max, Jul 27, 2015 in forum: Arduino IDE

Post

I tried with another computer (a windows pc), I followed all the instructions and installed the drivers but I had the same exact problem...

Post by: Max, Jul 20, 2015 in forum: Arduino IDE

Post

I also contacted the customer care and they suggested to try uploading the sketch as explained here (without the bossac patch):...

Post by: Max, Jul 16, 2015 in forum: Arduino IDE

Thread

Hi everyone, I’m trying to program the Arduino part of my Udoo Quad from an external computer but when I upload the sketch I get the following...

Thread by: Max, Jun 28, 2015, 15 replies, in forum: Arduino IDE