Recent Content by oodarioo

  1. oodarioo
    Post

    Controlling fan speed?

    @nophead I am no electrical engineer and have only a very rough understanding of these things... But does that mean, I should put a resistor...
    Post by: oodarioo, Nov 27, 2019 in forum: UDOO BOLT
  2. oodarioo
    Post

    Controlling fan speed?

    @nophead: If I connect Noctua +5V (yellow wire) to Arduino +5V, Noctua GND (black wire) to GND and Noctua PWM (blue wire) also to GND, the fan...
    Post by: oodarioo, Nov 26, 2019 in forum: UDOO BOLT
  3. oodarioo
    Post

    Controlling fan speed?

    Even after setting to default values and rechecking the wires, when following @Zgembo 's instructions, I have a fan that is always on. In fact,...
    Post by: oodarioo, Nov 26, 2019 in forum: UDOO BOLT
  4. oodarioo
    Post

    Controlling fan speed?

    Even after updating to Eva's linked BIOS, the Noctua fan keeps spinning, even when the Bolt is switched off. Must have done something wrong......
    Post by: oodarioo, Nov 22, 2019 in forum: UDOO BOLT
  5. oodarioo
    Post

    Controlling fan speed?

    I just bought the NF-A6x25 5V PWM and tried the described setup. In my case, I wired Noctua -> BOLT black -> black (GND?) yellow -> ** Arduino...
    Post by: oodarioo, Nov 20, 2019 in forum: UDOO BOLT