Recent Content by psycho

  1. psycho
    Post

    i2c + DUE don't talk!!

    Are you sure? I do not find the pullup resistors on the diagram.
    Post by: psycho, Mar 17, 2014 in forum: General Programming Discussion
  2. psycho
    Post

    i2c + DUE don't talk!!

    Also sda1 and scl1 have pull-up?
    Post by: psycho, Mar 17, 2014 in forum: General Programming Discussion
  3. psycho
    Post

    i2c + DUE don't talk!!

    I need set pull-up to off because I have them on the side of the sensor. right?
    Post by: psycho, Mar 17, 2014 in forum: General Programming Discussion
  4. psycho
    Post

    i2c + DUE don't talk!!

    You use SDA/SCL or SDA1/SCL1? Can You paste me an example?
    Post by: psycho, Mar 17, 2014 in forum: General Programming Discussion
  5. psycho
    Post

    i2c + DUE don't talk!!

    My sensor has 2 pull-up resistors of 4K7 on SDA and SCL as UDOO on pin 20-21. On schematics I see that SDA1 and SCL1 (pin 9-10 on J21 HEADER 10F)...
    Post by: psycho, Mar 16, 2014 in forum: General Programming Discussion
  6. psycho
    Post

    i2c + DUE don't talk!!

    I connect the sensor with 5V Udoo without pull-up resistors
    Post by: psycho, Mar 12, 2014 in forum: General Programming Discussion
  7. psycho
    Post

    i2c + DUE don't talk!!

    thanks I will ask directly on the Arduino forum
    Post by: psycho, Mar 9, 2014 in forum: General Programming Discussion
  8. psycho
    Thread

    i2c + DUE don't talk!!

    Hi, I can not use the GY-521 sensor through Arduino UDOO. I followed this example sketch (# http://playground.arduino.cc/Main/I2cScanner....
    Thread by: psycho, Mar 9, 2014, 27 replies, in forum: General Programming Discussion