Just wanted to provide an update. I purchased a B+M Key to B key adapter so I did not damage the Udoo board/M.2 card when I originally soldered on...
Do you know if the M.2 connections for the USB communications are pulled low or high on the udoo board, or if they are left floating?
I cut an old USB2.0 cable and I was able to wire on the D+/D- lines to the M.2 interface but my USB connection failed to enumerate. Both my ground...
Ahh you are correct, I've never worked with I2C before but is there anyway to repurpose these ports for my use? Do you have any other suggestions...
Hello, I'm working on a project where I have an M.2 device Key B that needs to use the USB and PCIE interface. I know that USB is supported on a B...
Separate names with a comma.
