Recent Content by sled

  1. sled
    Post

    Recompiling the Kernel to get PWM on Mx6

    hi, I think you can only output PWM signals (not a 100% sure though) What I've found so far is a good thread on the freescale forum:...
    Post by: sled, Nov 22, 2013 in forum: Kernels
  2. sled
    Post

    Solder Blob on SAM3X ?

    I just tried the default SD Linaro image and everything seemed to work even uploading an empty sketch to the arduino worked fine...
    Post by: sled, Nov 20, 2013 in forum: General Discussion
  3. sled
    Post

    Solder Blob on SAM3X ?

    As far as I can tell from the datasheet, it's the PIN 113 and PIN 114 which is PB0 and PB1. The UDOO schematic labels PB0 and PB1 with BOOT_SD1...
    Post by: sled, Nov 20, 2013 in forum: General Discussion
  4. sled
    Thread

    Solder Blob on SAM3X ?

    Hi, I've received my UDOO today and I discovered something that looks like a solder blob, shortening two pins on the SAM3X. Can you tell me if...
    Thread by: sled, Nov 20, 2013, 4 replies, in forum: General Discussion
  5. sled
    Post

    Programming for UDOO

    Hi, could you tell me how data can be transferred (UART, SPI, ...) between the SAM3x and the iMX6? :) Thanks! Simon
    Post by: sled, Sep 25, 2013 in forum: General Programming Discussion