Recent Content by virtualbruno

  1. virtualbruno
    Post

    no access on 192.168.7.2

    ektor5 thanks for your offer to help. Before I discard the card as a hardware problem, I still curious if it can be fixed. I can access the...
    Post by: virtualbruno, May 29, 2016 in forum: UDOO NEO
  2. virtualbruno
    Post

    no access on 192.168.7.2

    new SD card, no update, identical, ONLY Ubuntu can see 192.168.7.2, ONLY hardwired connection. udooer@udooneo:~$ ifconfig eth0 Link...
    Post by: virtualbruno, May 17, 2016 in forum: UDOO NEO
  3. virtualbruno
    Thread

    no access on 192.168.7.2

    These are the steps I took to debug this frustrating problem: - wiped the SD card clean by writing "1"s on all 15GB - restored the image from an...
    Thread by: virtualbruno, May 17, 2016, 7 replies, in forum: UDOO NEO
  4. virtualbruno
    Post

    A9 Serial Port problem

    Device Tree editor confirms the port is available after re-boot but python throws an error code 1: LXTerminal reports SerialException could not...
    Post by: virtualbruno, Mar 4, 2016 in forum: UDOO NEO
  5. virtualbruno
    Post

    A9 Serial Port problem

    Thanks Walter! Tricky to find I will check it out right away and post back.
    Post by: virtualbruno, Mar 4, 2016 in forum: UDOO NEO
  6. virtualbruno
    Post

    A9 Serial Port problem

    I am trying to connect to the A9 Serial port UART#6, so far successfully connected via python to /dev/ttyMCC to communicate with the M4 ( a small...
    Post by: virtualbruno, Mar 3, 2016 in forum: UDOO NEO
  7. virtualbruno
    Post

    9-axis motion sensor on Udoo Neo

    Thank You Andrea for your response. I tried the sample code right away. Please understand I am an electrical type with very little software...
    Post by: virtualbruno, Jan 28, 2016 in forum: General Discussion
  8. virtualbruno
    Post

    No HDMI cable Any way to use the VNC or similar to run Ubuntu?

    Thanks Andrea I have a VNC connection. I was just wondering if I could start Ubuntu? my options on the VNC screen are Arduino, terminal, and...
    Post by: virtualbruno, Nov 24, 2015 in forum: UDOO NEO
  9. virtualbruno
    Thread

    No HDMI cable Any way to use the VNC or similar to run Ubuntu?

    Hello, At the risk of demonstrating my grade of NOOBE, I have a question, that if possible may serve others. I have no HDMI cable nor monitor nor...
    Thread by: virtualbruno, Nov 23, 2015, 5 replies, in forum: UDOO NEO
  10. virtualbruno
    Thread

    9-axis motion sensor on Udoo Neo

    Hello, I am anxiously waiting for the new boards to be delivered. Could I have some advance information on the chip-set used for the 9-axis motion...
    Thread by: virtualbruno, Oct 9, 2015, 4 replies, in forum: General Discussion