Udoo Dual Programming Port Problem

Hi there, my programming port stopped working. Here's the setup:

1) MicroSD card 2Gb with no OS installed
2) CN3 usb port working (Windows plays in a loop the sound of hw attached and detached btw)

I've tested my usb cable with another UDOO of the same model and both ports are correctly working.
I've also tested with another MicroSd installed and Debian installed in it (using the official images) but the problem is still there.

How can I bring CN6 back to life?

Thanks,
Blackjack

 

Hi blackjack4,
one question, to exclude you burned the board: if you just connect the board via HDMI to an HDMI compatible screen and you power it up, does it boot?

 

Using a LVDS display I can see Udoo logo (but immediately after it reboots) so *fingers crossed* the board isn't burned.

 

You probably have burned u116, that is chip cp2105, that works as a USB to Serial.

 

Can I buy a spare replacement somewhere?
Thanks btw

EDIT: I've found a local shop, thanks btw

Is this the right one?
http://it.rs-online.com/web/p/controller-usb/7574987/

 

Dear blackjack4,
you better open a ticket instead.
Cheers