having trouble booting Lakka and openELEC So this is where it hangs, i'm using putty to see the startup process. any help would be awesome U-Boot SPL 2013.10-rc4 (May 22 2016 - 22:26:47) Boot Device: microSD card U-Boot 2013.10-rc4 (May 22 2016 - 22:26:47) CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR Board: Udoo Quad DRAM: 1 GiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment auto-detected panel HDMI Display: HDMI (1024x768) In: serial Out: serial Err: serial Net: using phy at 6 FEC [PRIME] Warning: failed to set MAC address Hit any key to stop autoboot: 0 mmc0 is current device SD/MMC found on device 0 653 bytes read in 11 ms (57.6 KiB/s) Importing environment from mmc (uEnv.txt)... Checking if uenvcmd is set ... Running default loadimage ... 5656792 bytes read in 263 ms (20.5 MiB/s) 32922 bytes read in 17 ms (1.8 MiB/s) Booting from mmc ... Kernel image @ 0x12000000 [ 0x000000 - 0x5650d8 ] ## Flattened Device Tree blob at 18000000 Booting using the fdt blob at 0x18000000 Using Device Tree in place at 18000000, end 1800b099 Starting kernel ...
