Yeah, you're going to want to follow the link in the "Serial Drivers" section of the Udoo download page: http://www.udoo.org/downloads/ eric -...
Re: Should I use 5V or 3.3V pins for programming arduino boa If the input (power) side of the button is hooked to the 5v rail then yes.. Bad!!!!...
Ouch! Sounds like fun, NOT! Hope everything went well and you're feeling ok!
Re: Should I use 5V or 3.3V pins for programming arduino boa for instance, let's say you use a sensor that is powered by 5V, but the outputs from...
Re: Should I use 5V or 3.3V pins for programming arduino boa what I mean is the following: Let's say you are plugging in a sensor that is...
Re: Should I use 5V or 3.3V pins for programming arduino boa 3.3V on the Udoo. It follows the Arduino Due physical pin standards. Remember,...
If I'm understanding what you're asking - then no, it does not come with those accessories. You have to order those in addition to the board. When...
I don't have the system in front of me to check this. So your best bet is to do the following: sudo apt-get update sudo apt-cache search idle...
IDLE is just a special text editor that is really useful for doing Python development that lets you run your python code directly from within the...
Ok, I think the issue here is that you're in the command line terminal, NOT in the IDLE IDE. IDLE is an application you'd have to launch (and I...
File-New in the menu at the top of the screen...?
Wish I could confirm, but so far I've had no success making this cable work... I don't think it hurts anything if you cross the DN/DP lines (other...
What sort of print area are you going to get out of that setup? That's always been my biggest issue with a lot of these 3D printers - they often...
Hey gang, Just some friendly suggestions to follow when posting questions asking for help with your set... Following these will greatly reduce...
No the cables are part of other cable bundles. They don't include it as the Dual units don't support SATA and they figured most people would just...
Wouldn't hurt to try it. It probably will boot up fine, I just would recommend not trying to power a lot of USB devices and such off it until you...
Cool. What about the extruder (hot end) and heated platform?
Ok, you have a couple options here: 1) buy the starter kit with all the cables from Udoo (easiest) 2) Buy a couple cables with the right...
Um, curious as to why you say it can only be done to 8GB? If you want to get a bigger card and use it all: Write the Udoo image of your choice...
Certainly doable.. You'll want to look into various temp + humidity sensors (places like sparkfun or pololu.com will have ones that would work...
Separate names with a comma.
