Re: cellular modem module for laptop Note that most of such modules do not have on-board SIM card slot but depend on laptop motherboard located...
Re: Macbook pro USB C charger (post #3) Insufficient info. Some models (such as the authentic one) cannot offer 20V 3A but just 16.5V 3.65A, but...
These diagrams are to show BOLT's internal hardware mappings, after device drivers are loaded successfully. To deal with missing software device...
Please try disable Windows fastboot feature to see if it helps.
For LTS vs latest/greatest on UDOO Bolt, the gaps are typically related to AMD support (SoC, GPU, etc.) and EMMC. One can always back-port the new...
You'll need a USB-C PD battery pack with the proper spec (19V 3A or 20V 3A). Lower ones (like what you've stated) won't work. Have you read...
That Consumer-IR is thru STM32 as part of CEC. The following link is for UDOO-X86, but should be very similar....
Usually the culprit is the boot-time eMMC support (assuming OS is installed there as the system drive.) Find a patch would be the workaround, if...
My 2 cents... Don't go crazy on getting the best of the best graphics card. It's going to be a mismatch on the CPU TDP. I.e., one don't put a...
EC (MEC1705) is in the loop. Unfortunately only it knows the actual CPU state and the S5 signal is not exposed. May be checking the...
Re: post #18 You'll need a separate, independently powered embedded controller (e.g., a standalone inexpensive Arduino Pro Mini, itself feed by...
Re: how you control the ATX Power Supply Turn on the ATX Power Supply by grounding the green-colored PS_ON# wire in main ATX connector.[ATTACH]
AHJ type: Left-Right-Gnd-Mic <-- this one OMTP type: Left-Right-Mic-Gnd...
Probably same design spec as UDOO x86. See https://www.udoo.org/forum/threads/question-regarding-x86-audio-input.6795/
Re: post 39 The hardware stability issues typically are related to power supply quality.
Here I am only discussing device driver issue, specific related to post #4 Code 10 This device cannot start. (You will see yellow exclamation...
You are on the right track. That is, the NVMe drive is ready to be used by the OS installer to install Operating System on to it. On the other...
Not sure, I am not an expert on Debian. I suspect it's still the ttyACM driver and permission issues. Suggest try Debian support there. E.g.,...
I am guessing the "buckled" type connector has the locking latch to make it harder to remove (pulling out) the cable. I think it's all up to you....
I would think so (but you'll have to try). UDOO Bolt's Grove interface is supposed to work with all Grove based sensor boards. After all, they are...
Separate names with a comma.
