Yes your right it has over current protection, however speaking from experience (with a numerous dev boards) the DC-DC converters can be...
Yes your right my mistake, not may adaptors for B-Key.
Not sure if this type of adapter could be used without verifying M2 is 75 pins and correctly routed.
Laura you need to clarify your statements, Braswell can only decode 8-bit H.265 HECV which won't be a commonly used media format. Most media will...
If you want to make a full image back of the SD card then the card shouldn't be mounted to run a OS, hence it needs to be removed from the NEO....
For 48 pins best to use a port expander, my opinion if you don't require interrupt handling then a port expander supporting i2c (ie MCP23017) is...
For AC/DC loads this type of board works fine with the neo (have tested), for the AC load you should also be able to use a solid state relay ....
The 5V rail comes via a AP3503F which rated to 3A so removing the APX809 you risk damaging the AP3503F. Ideally you should be powering all your...
You will need to wire up your own cable, they type of connector you require on the neo side is described in this post and pin out in this post....
On board battery connector (J8) is a JST 2.00mm (B2B-PH-SM4-TB(LF)(SN)) so you need the male 2.00 mm connector. You should be able to use a JST...
If you want to add rtc support best option is to add an rtc module (ds3231) as per my post (similar price to buying a connector).
Links below may help, if your not understanding the terminology in the links then you will have a steep learning curve and this may not be...
To be frank there is little chance of 'someone' porting libraries as there's not much progress on Arduino development for the Neo (see waltervl...
Your getting confused the address range is 0x02000000 to 0x020FFFFF. If your new to linux then this may not a good exercise to start with, as...
Another entry on the blog which demonstrates how the M4 could be used as a Pulse Oximeter. The M4 is also updating the SSD1306 display....
Not sure what your trying to achieve but on the A9 side AIPS 1 start/end is 0x02000000 to 0x020FFFFF see below: 0200_0000 020F_FFFF 1 MB Table...
I would be very careful before selecting Braswell for h.265 support, Braswell is limited to 8-bit HEVC and since its 1.4 HDMI that's only 4K...
Since you had no responses, waltervl how about you giving it a try?
The arbotix-m has a built-in Arduino MCU so do you don't need a Neo to control. You program it using Arduino IDE with the arbotix-m connected via...
This is not completely true the DynamixSheild initially was designed to implement half duplex serial support for the motors. The additional i/o...
Separate names with a comma.
