Ok, thanks for looking into this, delba. /v
Hi, I filed an RMA ticket (# 763402) for my Quad 1 week back. Have not heard a single thing after the auto-ack email. I thought the ticketing...
I think that comp is meant for an RTC (instead of a 3V coin cell). The RTC coin cells used in typical PC motherboards are rechargeable types,...
As evident from many sources, the ext psu needs to be rated 12v providing at least 2Amps+ - definitely not what 2 AA (~3v) can provide. Min is at...
Same issue here too... Brand new UDOO-Quad, and won't boot no matter what. Followed the FAQ debugging guide and steps on forum posts, but to no...
Yes, but presently, it can be formatted to use only 8GB. Yes, rather, it is recommended :-)
With 2 GB RAM, suite of sensors, std JST-jumpers - all for less than say $175 price - we could very well have the next gen :roll: YouDo2 !
Cost may be an issue... . UDOO + shield may be ~$200. Some low-cost options may be: . Student's laptop + due/shield, . Beaglebone black +...
Thanks for the clarification. I was confused between this and the "Ext. Bat. J1" (also a different JST type) connector... If J1 is meant for an...
Looks like some bad labeling - typically, when they say "-IN" its an "input" - so if that were right, this should've been the equivalent of a 12V...
Great idea for the labels. Thx. Can you shed some light on the SATA drive (such as power source etc). Also, is that a fan connection (J4 ?) to...
Thanks for the confirmation. /v
Thanks shorack for info and idea re the jumper wires... will try the jumper wires, but hopefully will not damage the pins on the J4 hdr. So, if...
Folks, Pardon my limited hw knowledge, but have a couple of questions on the onboard J4 connector wrt to adding an external fan... Got a typical...
Re: New cases - 40mm fan & HDD options added - updated Oct.3 Wondering why the need for two fans and where they would get mounted on the case....
Hi Kris, On the UDOO board, where are you getting the 12v (VIN) and 3.3V taps from ? Or are you using an external supply/SDD-dock ? thx, /v
Re: Created new cases - open to feedback - design updated Oc Thanks for the info, Kris. I installed SolidWorks E Drawings viewer, but it doesn't...
Re: Created new cases - open to feedback - design updated Oc 'am able to arrive at reasonably accurate dimensional measurements using the 3D...
Re: Created new cases - open to feedback - design updated Oc Nice design - looks great. A noob question... I downloaded the Quad's Mechanical...
If the external SATA SSD requires 12v, then one option may be, is to: . get 5v from J12 pin 1 (VCC_SW) . get 12v from J23 pin 8 (VIN) and...
Separate names with a comma.
