That happens also with a fresh installation of UDOOBuntu2rc2? Can you please describe your configuration (devices attached, os, post dmesg)? Thanks
Actually, no. You need to fopen the device, and then fput "erase". I successfully managed to erase/reset with the following command:...
Other info? VM Architecture, VM version... Also, have you updated your Ubuntu 14.04? mkudoobuntu uses a chroot with a qemu-static emulation... It...
@all, Please use the bossac application. The pins are used by the udoo_ard driver, so they aren't accessible by the gpio driver. You can also use...
Hi there, Maybe you were out of memory... Can you give more information on the machine you're using? Also share dmesg if you can.
Try deleting ~/.arduino15 on Linux on Windows: Arduino IDE 1.6.5r5 and previous: C:\Users\(username)\AppData\Roaming\Arduino15 Arduino IDE 1.6.6...
Hi there, It could be that github were down, the link is good. Try again and let me know.
Hi Maurice, Did you check that you're using the correct soundcard in the traybar? It could be that you're using the HDMI audio. Ek5
Hi there, Yes, they are compatible. You only need the correct cable you can buy from...
Hi there, They simply set the CR (Control Register) of the PWM module. Check the Reference Manual of the IMX6SX for further information about it....
Hi there, Seems a really big build! But you'll unlikely use all the 4 contemporaneously, and I doubt that a hub would permit that either way. So...
All closed! Thanks for the feedback! Ek5
Hi again, You cannot include modules with build-in dependences and vice-versa. Make sure that mac80211 is a module or a built-in like the WLAN...
Hi there, No, it should be enabled by default, just open a browser and type http://192.168.7.2 Verify the state of the service with sudo service...
Hi there, Unfortunately we didn't have the chance to try that one, but we tried several games of the same generation and they work flawlessly. So...
Hi there, Can you please share your dmesg here (with a pastebin-like service)? Thanks
Seems a known issue, did you try with a standard CP210x Serial to USB converter attached to TX0 RX0? Ek5
Well, they are 10uW/cm^2 per 4.77mV, so it's 0.477mV per 1uW/cm^2. So I think it's 2.5 * 0.477mV = 1.1925 mV -> ~1.48 analog values.
If the previous calculations are correct, every 11.92mV corresponds to 15 analog value (1 analog value = 3.3V / 4096 = 0.8 mV ). Ek5
Closing, old thread
Separate names with a comma.
