Software Serial is not supported on the Neo (see my signature for the known issues topic). The best alternative is to connect your sensor to the...
The problem will be HDMI input as that is normally not supported. But perhaps on the Udoo Quad it is. You can transmit/stream video over wifi or...
http://www.tomshardware.com/charts/network-attached-storage-nas-charts/benchmarks,87.html
You can try to locate the create_dfu_udev_rule that normally is around here...
That is strange as it should be just the same. I used the following command to upload the sketch "MyProgram.ino" without any problems: arduino...
I think the easies way to get communication working is just to install the Arduino IDE including the Board manager as instructed on the Arduino...
You could try to increase the timeout check value in dht.h to a value that works. Below are the default values (65). #define DHTLIB_TIMEOUT (65)...
You have to recompile android kernel with your new settings: https://www.udoo.org/forum/threads/android-6-r1-resolution-changing.5104/#post-24663
It looks like there is a new version of the web config that is not node.js but PHP. https://github.com/UDOOboard/udoo-web-conf So perhaps try...
Additional, you can look into my example that I made for the Neo. It sends parameters and commands to the Arduino side through a web interface. It...
Arduino has its own command line interface that you can use in a sh. https://github.com/arduino/Arduino/blob/master/build/shared/manpage.adoc...
If you upload the blink example will the built in LED (pin 13) blink? How did you connect your LED? What resistor did you use?
The Arduino part of the Neo is not fully compatible with a normal Arduino as it has a completely different hardware architecture. Therefor a lot...
I believe there is a Neo library for the dht11. You have to use that one instead of some library found on the internet.
I believe this is a known bug. See for more info: https://www.udoo.org/forum/threads/boot-on-sd-card-works-only-after-ctrl-alt-suppr.8100/
2) see the discussion I referred to. Perhaps ask your question again there to get more answers.
There is no prescribed analog camera for the Udoo Neo. You will have to switch to a Udoo dual/quad or Udoo X86 to use opencv in combination with a...
It is a 3 wire connection isn't it? Perhaps 2 wires are changed? Check the pdf manual for details.
You can try to set all the UEFI settings to default if you are running v1.03 Else update to UEFI v1.03 and reset all settings to default to start...
Its not my cup of tea but did you check the settings of console redirection in UEFI? Page 48 of the PDF manual:...
Separate names with a comma.
