There are 2 client installation procedures: The normal one and one for older Udoobuntu version (like Udoo Quad) @Laura the introduction page is...
1st: You are aware that the Udoo X86 already has a build in IMU in the onboard Arduino 101? https://www.arduino.cc/en/Reference/CurieIMU 2nd:...
Perhaps @secuflag knows?
@Laura what is the status of IOT for Udoo dual/quad?
Perhaps SPI is not working correctly then. You could also put a large delay in setup().
The Arduino part of the Neo boots much faster than the Linux (A9) side. When sending data from Arduino to Linux without reading on the Linux side...
On the other hand after looking into the dtweb scripts you can compile it on the Neo itself in a terminal. Just do: cd /../../dtbkernel make -j1...
Here is the instructions to setup a build environment: https://www.udoo.org/docs-neo/Advanced_Topics/Compile_Linux_Kernel.html Then you can build...
You are missing this step: Save and close the file an than recompile al the dts files. Then copy all of them into the /boot/dts folder in your...
If your Neo boots into Linux or android these pins always give power.
Try another cable and another monitor or TV. The UEFI output is a little bit picky in accepting monitors. Also use a normal keyboard, not a...
Then something is wrong with your board or you are not measuring correctly. Are you putting 1 measuring pen on pin gnd and 1 on 5V? Does your Neo...
Take a look at the imager.sh script. There you can add an mkdir to add folders etc.
Attach a power supply? :-) Are you measuring the right pins? Arduino pins are the inside ones.
Sorry, I have no further clues.
You can use the standard available USB Serial device to communicate from N3710 to Curie and viceversa. Udoo X86 is the same as using a PC and a...
Why would you want to use xenomai if you already have a ROS system with OS on the board (Intel Curie aka Arduino 101)? I believe for Curie there...
Did you switch off I2C-2 on the A9 side as instructed on this documentation page?...
Search the forum: https://www.udoo.org/forum/threads/using-more-digital-pins-on-m4.5146/#post-23479
Use this instruction https://www.udoo.org/docs-neo/Arduino_M4_Processor/Use_more_digital_pins_on_M4.html
Separate names with a comma.
