Good Morning Everyone, I'm currently searching your forum and other sources to learn more about the Arduino101 and UDOO interface. My searches are coming up empty when asking whether we can control and trigger SLEEP MODE and/or POWER UP from the integrated ARDUINO 101. Are we able to use a GPIO to instruct the UDOO x86 to enter and exit sleep mode? For instance, if a voltage was present on an input pin, can we wake the processor using Windows 10? Thank you for any tips or reading material that you can share! I'll continue to read the x86 docs, and surf the internet for answers. If I find anything, I will update this thread.
I think remember there is a bios setting to tell if the STM can wake up the braswell or not. some info in this doc https://www.udoo.org/docs-x86/Ardui...aswell_Power_Management_From_Arduino_101.html
Perfect, thank you! I was just reading the GPIO section in the Hardware & Accessories link. You saved me some searching and reading!
