I have succesfully compiled the seco-cec.ko kernel module and am using bios 1.06. On boot, I see the following in dmesg: There isn't any CEC device created. All the GPIO settings in the bios seem to be enabled. Is there anything else I could try? Thanks.
It turns out I had to load the pinctrl-cherryview kernel module first, then the seco driver loaded correctly.
Hi @trs, Does this mean that you got the IR interface working? Is it possible to share instructions? Thanks.
Thanks for the information, I will try to figure it out for more. Keep sharing such informative post keep suggesting such post. My Lowes Life
