NEO's JTAG connector

Discussion in 'General Discussion' started by Luc Van Oostenryck, Nov 1, 2015.

  1. Luc Van Oostenryck

    Luc Van Oostenryck New Member

    Joined:
    Nov 1, 2015
    Messages:
    4
    Likes Received:
    0
    Hi,

    Does someone know what are the specs of the JTAG connector (J11)?
    I haven't found this info in the docs yet.
     
    Luc Van Oostenryck, Nov 1, 2015
    #1
  2. jas-mx

    jas-mx Active Member

    Joined:
    Dec 31, 2013
    Messages:
    407
    Likes Received:
    118
    I think you need a Molex 87832-1420 it is a 14pin 2mm header, sadly they didn't provide one as part of the package which is a shame as the M4 can't be debugged well enough through any other means.

    Also beware M4 and A9 are in a jtag chain therefore only one of the two may initially be visible. If the M4 is visible first, then the A9 needs to run for the M4 to be enabled.
     
    jas-mx, Nov 2, 2015
    #2
    Luc Van Oostenryck likes this.
  3. Luc Van Oostenryck

    Luc Van Oostenryck New Member

    Joined:
    Nov 1, 2015
    Messages:
    4
    Likes Received:
    0
    Thank you jas.
     
    Luc Van Oostenryck, Nov 4, 2015
    #3
  4. Andrea Rovai

    Andrea Rovai Well-Known Member

    Joined:
    Oct 27, 2014
    Messages:
    1,703
    Likes Received:
    240
    Dear folks,
    we are going to sell a JTAG debugger in a second time. There are not so many users asking for this, but we'd like to make this option available.
     
    Andrea Rovai, Nov 4, 2015
    #4

Share This Page