Hi everyone! Just got my first UDOO board, though there seems to be an issue with the pins 8-13 header. It appears that the header is offset by one slot so that pin 8 is missing its header and the last pin on the other end of the row sticks out through the mounting drill hole. I've attached a picture of it -- I was wondering if anyone else has this issue? It's a Rev. D board, I just ordered it Sunday and it came today. There is also some minor solder paste leftovers around the Atmel chip and a few of the components are turned slightly off axis. Nothing serious, but it may be that the pick-and-place machine for this batch was out of calibration.
I see. Sorry about that. If you want to replace the board please open a ticket in our Customer Care section http://www.udoo.org/customer-care/ asking for a RMA.
Thanks a lot! I contacted technical support shortly after posting here so I'm waiting on a reply from them for now...
It's been a few days since I requested an RMA and have yet to receive a response -- is there any way I can expedite the process?
