[SOLVED] Sensor brick connection issue

Finally getting around to trying the sensor bricks included with my UDOO Neo (full). Why is it that the sensor brick cables and connectors have 6-wires, and the connector on the Neo board only has 5-wires? Can't hook them up that way!
Thank you.

 

As in you can't connect the shipped bricks onto your Neo? "It works on my configuration" (Neo Full too). You didn't try to reverse the cables by any chance? The connectors are directional.

 

Duh!
Thanks Maurice, I don't know how I missed that.
Different size connectors on each end of the cable, and the two connectors on the bricks.
I must have tried to connect the output of the brick to the Neo (thus the cable end would be incorrect).
Thanks again!
Bryan